Erbauer ERP406IPD, Оригинальное руководство пользователя

Страница: 18 / 23

Fig. 1-2
A
B
7
4
3
B) TO REMOVE OR INSTALL BATTERY PACK
(See Fig. 1-2)
Depress the battery pack release button to release
and slide the battery pack out from your tool. After
recharge, slide it back into your tool. A simple push
and slight pressure will be sufficient.
OPERATION
1. COLLET LOCKING SLEEVE
Pull the collet locking sleeve forward. Fully insert
the desired bit into the chuck and release the collet
locking sleeve. The collet accepts only standard
1/4˝(6.35 mm) hexagonal shank accessories with
power groove. Do not use this tool as a drill. Tools
equipped with shut-off clutches are not designed
for drilling applications. The clutch can shut off
automatically and without warning. Attempting to
restart drilling after shut-off has been reached can
cause the tool to twist out of your hand until the clutch
again reaches shut-off. Do not attempt to insert quick
change type drill bits into this chuck.
2. REMOVING A BIT HOLDER, SOCKET OR
SCREWDRIVER BIT (See Fig. 2)
Pull the collet locking sleeve (7) forward. Take the
tool out of the chuck and release the collet locking
sleeve.
3.FORWARD, REVERSE ROTATION AND LOCK
CONTROL (See Fig. 3-1,3-2)
Your tool is equipped with a forward, reverse rotation
and lock control located above the on/off switch. It
was designed for changing rotation of the chuck and
for locking the on/off switch in the center position to
help prevent accidental start and accidental battery
discharge.
For forward rotation, (with chuck pointed away
from you) move the lever to the far left. For
reverse rotation move the lever to the far right. To
activate switch lock move the lever to the center off
position.
Warning: Never change the direction of
rotation when the chuck is rotating, wait
until it has stopped!
4. LED LIGHT (6)
To turn on the light simply press the on/off switch.
When you release the on/off switch, the light will be
Fig. 2
A
B
7
4
3
7
3
8
9
Fig. 1
Fig. 4
Fig. 3
Fig. 2
Fig. 5
Fig. 8
Fig. 7
Fig. 6
10