Erbauer ERI691COM, Оригинальное руководство пользователя

Страница: 22 / 28

information regarding available recycling and/or
disposal options. Discharge your battery pack by
operating your drill, then remove the battery pack
from the drill housing and cover the battery pack
connections with heavy-duty adhesive tape to
prevent short circuit and energy discharge. Do not
attempt to open or remove any of the components.
12. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for the power tool cannot
be subject to overload. When the load is too high
or the allowable battery temperature of 75°C is
exceeded, the electronic control switches off the
power tool until the temperature is in the optimum
temperature range again.
13. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep
discharging by the “Discharging Protection
System”. When the battery is empty, the machine
is switched off by means of a protective circuit: The
inserted tool no longer rotates.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on
top of the trigger, is positioned in the lock function.
Unlock the forward/reverse rotation control by
putting it into the required rotation position. Push
the trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the variable clutch,
you can find the variable clutch between the chuck
and the drill body. Position 1 is the lowest torque
(screw driving force) and position 21 is the highest
torque (screw driving force). Position is for drill
operation. Position is for hammer drill operation.
Regulate the torque adjusting ring to a higher
position to reach the best result.