4
2
1
1
2
Red Flashing
Green Off
Defective battery, after
pre-charge 30 minutes with
trickle current, the total
battery voltage is still less
than 15.0v.
Red ON
Green Off
Charging
Green ON
Red Off
Power On and Fully
Charged
Green Flashing
Red Off
The temperature of battery
pack is less than 0
℃
or
more than 40
℃
4. Remove or install battery pack
Press the battery pack latch and remove the
battery pack from the saw. After recharge slide
the battery pack into saw’s battery port. A simple
push and slight pressure will be sufficient.
5. Safety on/off switch (See Fig.3)
Your switch is locked off to prevent accidental
starting. Depress lock-off button (2) then on/off
switch (1) and release lock-off button (2). Your
switch is now on. To switch off just release the
on/off switch.
The speed of the blade can be adjusted by the
pressure you apply to the switch. To increase
the speed, apply more pressure to the switch. To
decrease the speed, apply less pressure.
6. Hand grip areas (See Fig.4)
Always hold your saw firmly with both hands
when operating.
7. Tool-less blade fitting
Press the bland clamp button, insert the blade
shank into the blade clamp through the blade
guard until it stops. Ensure the small hole in the
blade is on the pin in the clamp then release the
button (4) (See Fig.5). Pull up on blade to make
sure that it is locked in. To remove a blade, carry
out these instructions in reverse order.
Warning:
Blade teeth are very sharp.
For best cutting results ensure you use
a saw blade suited to the material and cut
quality you need.
It is possible to make cuts extremely close to
Fig 3
Fig 4
Fig 5
CSR18L.1-M-071008.indd 10
2007-10-9 17:16:01
