Erbauer ERB800RL, Руководство пользователя

Страница: 9 / 16

800W ALL PURPOSE SAW
Fig 2
OPERATION INSTRUCTIONS
Warning!
Before using this tool, make sure
you read the instructions carefully.
Note:
Make sure to disconnect the all purpose
saw from mains supply before fixing any
accessories.
1. ON/OFF TRIGGER SWITCH
Depress to start and release to stop your tool.
2. VARIABLE SPEED CONTROL
Your tool is equipped with a variable speed
controlled trigger switch. The tool can be turned
“ON” or “OFF” by squeezing or releasing the
trigger. The blade plunger stroke rate can be
adjusted from the minimum to maximum by
the pressure you apply to the trigger. Apply
more pressure to increase the speed and release
pressure to decrease speed.
3. HAND GRIP
Always hold your saw firmly with both hands
when operating the tool.
4. TOOL-LESS BLADE FITTING
(see fig2)
To install blade disconnect the saw from power
supply. If necessary, extend the pivoting blade
foot away from the blade clamp for easier access.
Pull the tool-less blade clamp lever up with
your thumb, as shown. Insert the blade into the
saw’s blade clamp and make sure that the blade
attaches to the blade pin inside the clamp. Push
down blade clamp lever to make sure the blade is
locked securely in place.
To remove blade disconnect saw from power
supply. If necessary, extend the pivoting blade
foot away from the blade clamp for easier
access. First, pull the blade clamp lever up with
your thumb, then pull the blade out of the blade
clamp.
5. BLADE GUARD ADJUSTMENT
(see fig3)
If you need to reduce the cutting capacity of your
tool the pivoting blade foot may be adjusted as
follows: press the shoe adjusting button. Slide the
pivoting blade foot to give the required distance
from the end of the blade to the pivoting blade
foot (This distance equals new cutting capacity).
Then loosen the button, The pivoting blade foot
Fig 3
Fig 4
Fig 5
Tool-free blade clamp lever
Pendulum action control