Erbauer ERB611MSW, Оригинальное руководство пользователя

Страница: 21 / 40

ERBAUER 254MM (10”) SinglE BEVEl SliDing MiTRE SAW
Three laser module mounting/adjustment screws
are provided. Two (1,2) are positioned on the LH
side of the laser housing, and one (3) on the RH
side of the laser housing. These screws gently
hold the laser module in place and on alignment
by bearing on the laser modules casing. It is
important that during any adjustment the pressure
on the laser module casing is maintained as
closely as possible to the factory setting. Do not
over tighten any one screw – damage to the laser
casing could result. (See fig. 17&18)
B Adjusting the Angle of the laser guide
1) Loosen the single screw on the RH side of
the laser housing ½ a turn.
2)Turn the laser element in the desired direction
to adjust the laser angle.
3)Retighten the adjustment screw.
C Aligning the laser Beam
1)Use the two adjusting screws on the LH side
of the laser housing.
2)Adjust both screws until laser alignment is
achieved.
WARning!
Use only the correct sized
allen key when adjusting these screws.
Turn one screw at a time and only ¼ turn
in either direction before checking laser
alignment. Maintain as far as possible the
original factory pressure setting that these
screws exert on the laser module.
Fig 18
Fig 17
1
3
2