Erbauer ERB567DRH, Руководство пользователя

Страница: 16 / 22

WORK HINTS FOR YOUR BREAKER
If your power tool becomes too hot, set the speed
to maximum and run a no load for 2-3 minutes to
cool the motor.
Always use sharp good quality chisels. The
performance of
the tool is dependent on the quality of the bits
used.
• Reduce the pressure on the chisel bit when it is
about to break through.
• Always operate tool using both the handle and
the front handle.
• Make sure that you wear safety glasses and
protective gloves.
• Do not apply excessive pressure to the tool.
Expressive force does not speed up the work.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see
sparks through the ventilation slots. This is normal
and will not damage your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your breaker do not start, check the plug and
fuse on the mains supply first.
2. If your concrete breaker use in low efficiency,
please check whether the chisel is blunt.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice. For
further information visit www.recycle-more.co.uk.