Erbauer ERB400SWP, Руководство пользователя

Страница: 4 / 16

4
400W AUTOMATIC STAINLESS STEEL SUBMERSIBLE CLEAN WATER PUMP
SAFETY INSTRUCTIONS
Please note: Before assembling and putting the pump into operation, in all cases read
through the operating manual. For safety reasons, those persons who have not read
through the operating manual may not use the pump. The pump is intended for use
ONLY by adults who have fully read and understand these instructions. Whenever
Water and Electric are in the same place there are risks of electrocution and serious
injury or death. Always disconnect the pump RCCB from the mains before placing your
hand in the water to service maintain or clean the pump. The pump is ONLY intended
for use with water or water based (aqueous solutions) which have a content of at least
90% water. DO NOT use this pump for flammable, toxic, corrosive or irritant fluids.
a) The user is responsible towards third parties with regard to the use of the pump
(water installations, etc.)
b) Only operate on connections with residual current circuit breakers! Your
pump is fitted with an RCCB as standard. If removed for pump installation, it
must be replaced before the pump is switched on.
c) Before putting into operation, a qualified electrician must check that the required
electrical safety measures are place.
d) The electrical connection is to be made via an electrical socket.
e) Check the voltage. The specified technical information on the label must
correspond to the voltage of the electrical equipment.
f) During the operation of the pump, persons may not remain in the pumped
medium.
g) The temperature of the fluid to be pumped may not exceed 35°C. In the event that
extension cables are used, they must be exclusively made out of rubber, type H07
RN-F, and in compliance with norm DIN 57282 or DIN 57245. Never handle, lift or
carry the pump connected to electrical power by the cord. Make sure that the
connection power outlet is kept away from water and moisture and that the
power plug is protected from moisture.
h) Before putting the pump into operation, check that the electrical cord and
electrical residual current circuit breaker are not damaged.
i) Always pull out the residual current circuit breaker from the electrical socket
before performing work on the pump.
j) In the event that the pump is to be installed in a storm drain, one must
subsequently close the storm drain with a cover in order to safeguard the safety
of pedestrians.
k) Reinforce the mounting of the discharge pipe with the use of a pipe clip. Adhere
to the maximum immersion depth (See: Technical Information). The owner
(user)of the pump has the duty to take precautionary measures (installation of an
alarm device, back-up pump, etc.) for the avoidance and prevention of potential
damages (such as flooded rooms, etc.) due to faulty pump operation (because of
breakdowns or defects).On sandy or silty ground it is necessary to let the pump
run hanging by a rope or chain or to situate the pump on a suitable base in order
to prevent the sinking of the intake section.