Erbauer ERB378SDR, Оригинальное руководство пользователя

Страница: 15 / 20

1200W 4" BELT SANDER
WORKING HINTS FOR YOUR TOOL
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speed. Always
use a sanding belt suited to the material you wish to
sand. Always ensure the work-piece is firmly held or
clamped to prevent movement. Support large panels
close to the sanding area. Any movement of the
material may affect the quality of the sanding finish.
Start your sander before sanding and turn off only
after stopping sanding. For best results, sand wood in
the direction of the grain. Do not start sanding without
the sanding belt fitted. Empty the dust bag every 5
minutes or sooner to ensure efficient dust collection.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your sander will not operate, check the power at
the mains plug.
2. If the sander does not abrade surface, checking
the sanding belt. If the sanding belt has been
worn, replace the new sanding belt and try again.
The sanding belt must be kept in a dry place.
3. If a fault can not be rectified return the sander to
an authorized dealer for repair.
Fig. 9
Fig. 10