Erbauer ERB373RSP, Руководство пользователя

Страница: 14 / 20

It is possible to make cuts extremely close to floors,
walls and other difficult areas. Insert the blade shank
into the blade clamp with the blade teeth facing up
(opposite to normal working position). This will make
cuts closer to the work surface. Using special flexible
blades insert the blade into the blade clamp with the
blade teeth facing down (normal working position). It
will allow flush pipe cutting.
WOOD CUTTINg
For easier control use low speed to start cutting, then
increase to the correct speed.
METAL CUTTINg
This saw has different metal cutting capacities
depending upon the type of blade being used and
metal being cut.
Use a finer blade for ferrous metals and a coarse
blade for non-ferrous metals.
When cutting thin gauge sheet metals, ALWAyS
clamp wood on both sides of the sheet. This will give
you a clean cut without excess vibration or tearing of
the metal.
DO NOT
force the cutting blade. Forcing the blade
will reduce blade life and cause the blade to break.
Note: We recommend that you spread a thin film of
oil or other coolant along the line of cut ahead of the
saw. This will allow easier operation and help extend
blade life. When cutting aluminum, use kerosene.