Erbauer ERB372BJC, Оригинальное руководство пользователя

Страница: 15 / 22

860W BISCUIT JOINTER
OPERATION INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
Intended use
The machine is intended for cutting grooves
for biscuit dowel joints in chipboard, hard- and
softwood, plywood, fibreboard.
ADJUSTMENT
1. ADJUSTING THE DEPTH OF CUT (See Fig.1)
With the cutting depth adjustment knob (7), the
depth-of-cut can be set. The knob has set stops for
four biscuit dowel sizes.
Correlation of the set stops to biscuit dowel sizes
and depths-of-cut:
marking
thickness
of material
Biscuit
dowel
Cutting
depth
0 8-12mm No.0 8.0mm
10 12-15mm No.10 10.0mm
20 >15mm No.20 12.3mm
Max. -- -- 14.0mm
When using resharpened cutting discs, the depth-
of-cut may possibly need to be readjusted. For this,
loosen the lock nut (A). Turn the knurled screw (B).
in clockwise or anticlockwise direction to adjust the
distance. Check the cutting depth by carrying out
trial cuts. Afterwards, firmly tighten the lock nut (A)
again.
2. SETTING THE ADJUSTABLE HEIGHT STOP
(See Fig.2)
With the adjustable height / angle stop, the
distance between the upper surface of the
workpiece and the intended groove can be set.
Loosen the lock knob of the height stop (5). Set the
desired distance on the height scale (6) with the
pointer (C). Then tighten the lock knob (5).
3. SETTING THE CUTTING ANGLE (See Fig.3)
The stop (12) also enables cutting of grooves on
mitre joints.
To adjust the cutting angle, loosen the lock knob
(10). Pivot the angle stop (12) until the desired
angle is set on the scale (11) with the pointer (D).
Then tighten the lock knob (10) again.
Fig. 1
Fig. 4
Fig. 3
A
Fig. 5
Fig. 8
Fig. 9
Fig. 7
Fig. 6
12
11
18
13
8
4
10
7
5 6
B
C
D
E
Fig. 2