Erbauer ERB2504SE, Руководство пользователя

Страница: 20 / 30

ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
2. Adjusting 90° positive stop of blade
1) Raise the saw blade to its maximum height.
2) Loosen the saw blade tilt lock handle and move
the saw blade tilting mechanism to the left until
it hits against the stopper. Then tighten the saw
blade tilt lock handle.
3) Use a square (1) to check the saw blade is at
90° (See fi g. 15).
4) If the saw blade is not at 90°, loosen the saw
blade tilt lock handle. Adjust the screws (2) a few
turns and move the saw blade tilting mechanism
until the blade is at 90° to the table (See fi g. 14).
5) Tighten the saw blade tilt lock handle after
adjustment.
6) Loosen the screw of the tilt pointer and set the
pointer to 0°.
3. Adjusting 45° positive stop of blade
1) Raise the saw blade to its maximum height.
2) Loosen the saw blade tilt lock handle and move
the saw blade tilting mechanism to the right until
it hits against the stopper. Then tighten the saw
blade tilt lock handle.
3) Use a 45° gauge (2) to check the saw blade is at
45° (See fi g. 15).
4) If the saw blade is not at 45°, loosen the saw
blade tilt lock handle. Adjust the screws (3) a few
turns and move the saw blade tilting mechanism
until the blade is at 45° to the table (See fi g. 14).
5) Tighten the saw blade tilt lock handle after
adjustment.
6) Loosen the screw of the tilt pointer and set the
pointer to 45°.
4. Adjusting rip fence
1) The fence (1) is moved by lifting the handle
(2) and sliding the fence to the desired location.
Pushing down on the handle locks the fence in
place.
2) Position the fence on the right side of the table,
along the edge of the mitre gauge groove.
3) Lock the fence handle. The fence should be
parallel with the mitre gauge groove.
4) If adjustment is needed in order to make the
fence parallel to the groove, follow these steps:
●
Loosen the two bolts (3), and lift the handle (2).
●
Hold the fence bracket (4) fi rmly against the front
of the saw table. Move the far end of the fence until
it is parallel with the mitre gauge groove.
●
Push the handle down to lock it, and tighten both
screws.
Fig 15
Fig 16
1
2
22
1 3
4
6 7
5