Erbauer ERB238MSW, Оригинальное руководство пользователя

Страница: 25 / 40

ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
9. Adjusting fence squareness
1) Loosen the four fence locking bolts (1).
2) Lower the cutting arm and lock in position.
x Œ „x
against the blade and the ruler against the
fence(2) as shown.
\$ €[‚
the four fence locking bolts. „‡ V
Caution: If the saw has not been used recently,
#
$
5) After fence has been aligned, using a scrap piece
# # –
@$
10. Setting cutting depth
The depth of cut can be preset for even and
repetitive shallow cuts.
P \$ „‡ &Œ]—
HEAD section) until the teeth of the blade are at
the desired depth.
2) While holding the upper arm in that position,
turn the stop knob (1) until it touches the stop
plate (2).
3) Recheck the blade depth by moving the
cutting head front to back through the full
motion of a typical cut along the control arm.
„‡ Q
11. Adjusting cutting depth
!
was set at the factory. Check to see that the
! QxV
the table insert, and does not touch the control
arm throat or any part of the base or table. If the
! $"
1) Loosen the depth control screw locknut (3).
} !
the depth control screw.
x \$
! QxV
4) Recheck the blade depth by moving the
cutting head front to back through the full
motion of a cut along the control arm. If the
blade touches the inside of the control arm,
$ #
„‡ Q
Fig 25
Fig 26
1
3
2
1
2
3
1