Erbauer EHTIW18-Li, Оригинальное руководство пользователя

Страница: 19 / 28

19
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
Problem Tool/ Battery Status Possible cause Solution
Overload
protection
Product suddenly
Stops; The LED
work light (if fitted) is
flashing
Extremely high
torque, binding and
stalling situations,
overloading of the
tool
Relieve the load
immediately, reset the
tool by switching off and
back on again.
Temperature
extremely high
The first and the
third LED light of the
POWER BAR will be
flashing alternately
Battery temperature
exceeds 77°C during
operation
Cool down the battery to
below 77°C for operation
and below 57°C for
charging.
Low charge Power for the tool will
drop quickly; The first
LED on the POWER
BAR begins to flash
The battery pack is
under 5% charge
Remove the battery pack
from the tool and charge
it
Other
problems
Short charges Not fully charged Make sure that the
battery is fully charged
every time by allowing
the charger to complete
its full charging cycle
Poor storage
condition
Always remove battery
from the tool and charger
when not in use and
store in a dry secure
place. Avoid charging
or storing your battery
in temperatures below
5°C and above 40°C.
Cool down a hot battery
pack from a tool that has
just been operated for
approximately 30 minutes
before storage