19
18
CARE & MAINTENANCE
WARNING!
Always switch the product off, remove the battery pack and
let the product cool down before performing inspection, maintenance and
cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualified specialist!
BLADE CLEANING AND LUBRICATING
WARNING!
Wear safety gloves when working on the cutting device and
close to it! Use appropriate tools to remove debris e.g. a brush or wooden
stick! Never use your bare hands!
Keep the blade (1) clean and free of debris. Remove trimmings.
Apply a small amount of suitable lubricant on the cutting device to retain a good cutting
performance.
Keep the blade (1) sharp. Have a worn or damaged cutting device replaced with a new
one of the same type by a qualified specialist.
Adjustment of the distance between blades is not necessary, as this is predetermined by
the manufacturer.
If the cutting device overheats during operation, it is necessary to lubricate the internal
surfaces of the blades. (Fig. G)
WARNING!
This operation must only be performed when the blades
have stopped running and the motor is switched off.
CLEAN
• Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
• In particular clean the switches and air vents after every use with a cloth and brush.
• Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this product as they might be harmful to its surfaces.
MAINTENANCE
Your tool requires no maintenance.
There are no user serviceable parts in your power tool.
Before and after each use, check the product and accessories (or attachments) for wear
and damage. If required, exchange them for new ones as described in this instruction
manual. Observe the technical requirements.
TRANSPORTATION
WARNING!
Always carry the product by its main handle.
• Switch the product off and remove the battery pack.
• Protect the product from any heavy impact or strong vibrations which may occur during
transportation in vehicles.
• Secure the product to prevent it from slipping or falling over.
STORAGE
• Switch the product off and remove the battery pack.
• Clean the product as described above.
• Store the product and its accessories in a dark, dry, frost-free, well-ventilated place.
• Always store the product in a place that is inaccessible to children. The ideal storage
temperature is between 10 °C and 30 °C.
• We recommend using the original package for storage or covering the product with a
suitable cloth or enclosure to protect it against dust.
RECYCLING AND DISPOSAL
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice.
For further information visit www.recycle-more.co.uk
DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of the battery pack
properly.This battery pack contains Li-Ion batteries. Consult your local waste
authority for information regarding available recycling and/or disposal options.
Discharge your battery pack by operating your tool, then remove the battery
pack from the tool housing and cover the battery pack connections with heavy-
duty adhesive tape to prevent short circuit and energy discharge. Do not
attempt to open or remove any of the components.