17
16
BATTERY PACK POWER BAR
The Li-Ion battery pack (7) is equipped with a POWER BAR which is used to give an
indication of the battery pack’s remaining charge. Press the POWER BAR button (8) to
check battery charge as below. The LED will stay lit for approximately 5 seconds
.
8
76-100% Charge
51-75% Charge
26-50% Charge
5-25% Charge
under 5% Charge
Flash
On
Off
HOW TO USE THE BELT CLIP (B1, B2)
Screw the Belt clip (12) on the tool with the screw. The Belt clip can be hooked on your belt
or pocket, etc.
INSERTING OR REMOVING, SOCKET OR SCREWDRIVER BIT (C)
Pull the locking sleeve (2) forward. Fully insert the desired bit into the tool holder and
release the locking sleeve. Pull bit forward to ensure correct fitting. To remove, pull the
locking sleeve(2) forward and remove the bit.
USE
01
INTENDED USE
This tool is intended for the fastening and loosening of bolts, nuts and various threaded
fasteners. This tool is not intended for use as a drill.
02
OPERATION
ON / OFF SWITCH (D)
Depress the on/off switch (11) to start and release it to stop your driver. The on/ off switch is
fitted with a brake function which stops the spindle immediately when you quickly release
the switch. It is also a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
WARNING!
Do not operate for long periods at low speed because
excess heat will be produced internally.
SWITCH LOCK (E1)
The switch trigger can be locked in the OFF position. This helps to reduce the possibility
of accidental starting when not in use. To lock the switch trigger, place the rotation control
(4) in the centre position.
FORWARD AND REVERSE ROTATION CONTROL (E2-E3)
WARNING!
Only change the rotational direction when the product is
switched off and has come to a complete stop! Shifting during rotation of the
spindle can cause damage to the tool.
Move the forward / reverse rotation control (4) to the left in order to use the product in a
clockwise rotational mode
.
Move the forward / reverse rotation control (4) to the right in order to use the product in
anticlockwise rotational mode.
