5. DMX-512 control connections
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to
the male 3-pin XLR input of the moving head. You can chain multiple
Moving heads be connected together through serial linking. The cable needed should be two core,
screened cable with XLR input and output connectors. Please refer to the diagram below.
DMX-512 connection with DMX terminator
For installations where the DMX cable has to run a long distance or is in an electrically noisy environment,
such as in a discotheque, it is recommended to use a DMX terminator. This helps in preventing corruption
of the digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω
resistor connected between pins 2 and 3,which is then plugged into the output XLR socket of the last
fixture in the chain. Please see illustrations below.
.5.
1
2
3
PIN 3
PIN 2
120
Ω
6. Menu Operations
MENU
Address
1-512
Chin
Engh
Norm
RunMode
Language
Display
ChanMode
DMX Clear
Xreverse
Yreverse
XY Fback
Return
Reve
14CH
16CH
DMX
Musc
Auto
Off
On
Off
On
On
Off
▲
Pan
Tilt
Gobo
Gobo Auto
Colour
Focus
Prism
PrismRot
00-40
00-40
Yes
No
0-255
0-255
0-255
0-255
0-255
0-255
0-255
0-255
SYS Set
Rectify
ChanLevel
Control
Reset
ExitMenu
▲
Off
On
Language setting
Display turn up 180
degree setting
Channel mode
setting
Run mode setting
DMX Signal clear
Pan Invert setting
Tilt Invert setting
Pan/Tilt sensor
detection
Return to menu
Adjust the
Default position
of these parts
DMX value of
each channel
Manual control of
each channel
.6.
