Charging the control unit
Please turn the unit off before charging it.
Please note:
Completely charge the device prior to first use! Charging an
empty accumulator takes approximately 2 hours. There are two
sockets located at the front side of the control unit to connect
the power supply and the applicator.
Plug the charger into a 240V outlet and then plug the small
circular connector of the plug-in power supply into the socket
located at the front side of the control unit. The plug-in power
supply is only intended for charging the accumulator. Please
disconnect the plug-in power supply from the control unit for
the duration of the application.
To connect the control unit to the applicator, insert the plug of
the applicator into the large socket located at the front side of
the control unit and close it.
Turning the control unit on and
selecting different programmes
You EQUUSIR control unit comes factory equipped with 9 basic
programmes. In order to retrieve the programmes at the pulse
generator, please press the (on/off) button on the front side of
the control unit and hold the button until the unit indicates its
readiness by sounding a signal tone. The LED-display is now lit
permanently to indicate the „RELAXING“ programme.
By repeatedly pushing the (on/off) button, you can select your
desired programme.
After the “ACTIVATING” programme, the LED display reverts
back to the “Calming” programme and starts flashing. You
are in the second programme level. By pushing the (on/off)
button again, you can select the programmes from the second
programme level.
Running times
of programmes:
PROGRAMME LEVEL
RELAXING: 3 hours
CALMING: 3 hours
REGENERATING: 3 hours
VITALISING: 3 hours
ACTIVATING: not active
PROGRAMME LEVEL
RELAXING: 30 min.
CALMING: 30 min.
REGENERATE: 30 min.
VITALISING: 30 min.
ACTIVATING: 10 hours
1
2
