Setting The Alarm Time
* Slide the TIME-LOCK-ALARM set switch to ALARM set position.
* The hour digits will flash indicating it needs to be set. Press numeric buttons to enter hour digits.
The LED display will show the numbers that you have entered.
* After 4 seconds, the minute digits will flash indicating it needs to be set.
Press numeric buttons to enter minute digits. The LED display will show the numbers that you
have entered.
* Press RESET button to change your setting. Press PM button to show pm time.
Slide TIME-LOCK-ALARM set switch to LOCK after Alarm was set.
Using The Alarm
* Slide the
HI/LO/OFF
alarm switch to
HI
position for loud alarm sound.
The alarm indicator will be lit.
* Slide the
HI/LO/OFF
alarm switch to
LO
position for regular alarm sound.
The alarm indicator will be lit.
* Slide the
HI/LO/OFF
alarm switch to
OFF
position to turn OFF alarm.
The alarm indicator will turn off.
Using The Snooze
* Press the SNOOZE button when the alarm sounds to stop the alarm sound.
The alarm will sound again in nine minutes.
* The snooze function can be repeated.
* Slide the HI/LO/OFF alarm switch to OFF position to turn off the alarm.
Using The Display Dimmer Switch
* Slide the
HI/LO
display dimmer switch to
HI
position for brighter display.
* Slide the
HI/LO
display dimmer switch to
LO
position for normal display.
Battery Backup
* Insert two “AAA” batteries into the battery compartment at the back of the clock.
If the power is interrupted. The battery will keep the alarm and time settings until
the power is restored. The LED display will not light-up but the alarm will sound at
the preset alarm time. If there is no battery installed but the power is interrupted,
the display will flash at 12:00 and the time and alarm need to be set again.
Battery Warning
Clean the battery contacts and also those of the device prior to battery installation.
Follow the polarity (+) and (-) to place battery.
FCC INFORMATION:
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
www.equitybylacrosse.com/support
