3
PREPARATION
assembly
Insert handle into the handle sleeve. Tighten the bolt on handle sleeve to prevent accidental removal of handle while
in use.
Before Use
1.
Verify that the product and application are compatible, if in doubt contact your local Fastenal Representative or
visit www.fastenal.com to locate your nearest store.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, locate and turn the release valve (handle):
a.
Clockwise until firm resistance is felt to further turning. This is the ‘CLOSED’ release valve position used to
raise the saddle.
b.
Counter-clockwise, but no more than 1/2 a turn from the closed position. This is the ‘OPEN’ release valve
position used to lower the saddle.
4. With saddle fully lowered, remove the oil filler plug. *Pump 6 to 8 full strokes. Check oil level. Proper oil level will vary
from just covering the ram cylinder to 3/16” above it as seen from the oil filler hole. Reinstall the oil filler plug.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into
service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with factory
authorized replacement parts only.
*Bleeding / venting trapped air
With the release valve in the OPEN position (3b.) and with saddle fully lowered, locate and remove the oil filler
plug. Pump 6 to 8 full strokes. This will help release any pressurized air which may be trapped within the reservoir.
Reinstall the oil filler plug.
!
WARNING
•
Study, understand, and follow
all printed
materials provided with/on this product
before use
.
•
do not
exceed rated capacity.
• Use
only
on hard, level surface.
•
this is a lifting device only!
•
Immediately
after lifting, support the load with
a pair
of appropriately rated jack stands.
• Lift
only
on areas of the vehicle as specified by
the vehicle manufacturer.
•
do not
move or
dolly
the
vehicle
while on the jack.
• No alterations shall be made to this product.
•
Failure to heed
these marking may
result
in
personal injury and/or property damage
.
To avoid
crushing and related injuries
:
•
never
work on, under or around a load supported
only by hydraulic jack.
•
always
use adequately rated jack stands.
• Chock each unlifted tire in both directions.
•
do not
use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
•
Be alert
and
sober
when using this product. Do not
operate under the influence of drugs or alcohol.
!
WARNING
X
