INTRODUCTION
Models GL1800PB, GL1800C, GL3000C and GLW3500 induction cookers are
designed to offer fast, high quality cooking. They are constructed of food service quality
stainless steel for commercial applications, and tinted tempered (safety) vitroceramic
glass. All units require induction ready pans to operate. The units and touch
activated control panels are fully sealed on top to prevent liquid intrusion. Controls
depend on model, and may include a power button, + and – buttons to raise and lower
the power setting and timer setting, a button to switch display between power and
timer setting. Display indicators allow for precise control of the temperature/power
and timer settings.
Specifications:
Model
Electrical Plug
Configuration
GL1800PB
120V, 50/60 Hz, 1 PH, 1.8 KW, 15A NEMA-5-15P/5-20P (CAN)
GL1800C
120V, 50/60 Hz, 1 PH, 1.8KW, 15A NEMA-5-15P/5-20P (CAN)
GL3000C
208/240V, 50/60 Hz, 1 PH, 3KW, 3/15A
NEMA-6-20P
GLW3500
208/240V, 50/60 Hz, 1 PH, 3.5KW, 15/17A
NEMA-L6-30P
All models must be installed on a dedicated circuit rated not less than 25% over the
maximum current indicated for that model above, in accordance with NEC standards.
Plug ends have been appropriately installed to meet these requirements.
INSTALLATION
The
Induction Cooker
needs to be connected to a grounded outlet of proper voltage
of 120V or 208/240V, single-phase, 50/60Hz. DO NOT place the unit in a damp area
or near steam sources, or where heat from other equipment may affect the unit, by
raising its internal temperature. When positioning the appliance, make sure that the
bottom ventilation holes are not blocked. Maintain 2” clearance at each side and rear
of the appliance.
La cuisson par induction doit être connecté à une prise de terre de tension correcte de
208/240V, monophasé, 50/60 Hz. NE placez PAS l'appareil dans un endroit humide ou
à proximité de vapeur sources, ou où la chaleur provenant d'autres appareils peut avoir
une incidence sur l'unité, en augmentant sa température interne. Lors du
positionnement de l'appareil, assurez-vous que le bas orifices de ventilation ne sont pas
obstrués. Maintenir 2" de dégagement de chaque côté, à l'arrière et le dessus de
l'appareil.
