Display normal mode is for floor standing the unit.
Display inversion mode is for hanging the unit from a ceiling.
Auto-Test
Press the
MENU
button to select
. Press the
ENTER
button and the unit will
run a self-test with its built-in programs. To go back to the functions without any
changes press the
MENU
button again. Press and hold the
MENU
button for one
second or wait for one minute to go back to the main menu.
Reset
Press the
MENU
button to select
. Press the
ENTER
button and all channels of
the unit will return to their standard position.
4. How To Control The Unit
1. Master/slave built-in preprogram function
2. Universal DMX controller
There is no need to turn the unit off when you change the DMX address as new DMX
address setting will be affected at once. Every time you turn the unit on, it will show
“
”
on the display and move all the motors to their ‘home’ position and you
may hear some noises for about 20 seconds. After that the unit will be ready to
receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other
units to give an automatic, sound activated, synchronized light show. This function
is good when you want an instant show. You have to set the first unit as master and
select
show 1
,
show 2
,
show 3
or
show 4
from the
Show Mode
. The other units
must be set to
either
Slave 1
(normal) or
Slave 2
(2 light show) mode. A DMX
cable between the units for daisy chaining is needed.
2-light show
In
slave mode
,
Slave 1
means the unit works normally and
Slave 2
means 2-light
show. In order to create a great light show, you can set
Slave 2
on the second unit
to get contrast movement to each other, even if you have two units only.
4.2 DMX Controller
By using a universal DMX controller to control the units, you will need to set a DMX
address from 1 to 512 so that the units can receive a DMX signal.
Press the
MENU
button until
is showing on the display. Press the
ENTER
button and the display will blink. Use the
DOWN
and
UP
buttons to change the
DMX-512 address. Once the address has been selected, press the
ENTER
button to
confirm. To go back to the functions without any changes press the
MENU
button
again. Press and hold the
MENU
button one second or wait for one minute to go
back to the main menu.
Please refer to the below diagram to address your first 4 units
：
Channel
mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
8 channels
1
9
17
25
4.3 DMX 512 Configuration
1 channel DMX chart
Channel
Value
Function
CH1
000-007
Blackout
008-037
Show 1
Sound activated
038-067
Show 2
068-097
Show 3
098-127
Show 4
128-157
Show 5
158-187
Show 6
188-217
Show 7
218-247
Show 8
248-255
Random show 1-8
