Equinox Power Flower & Impact Flower
Operation Modes
9
Factory reset menu mode
Error reset:
Note: you only need to go into this mode if the rear of the unit shows
-err
on the LED display on start up.
To access the setting mode, press the
“MODE”
button on the rear of the unit to show
Set
on the LED display. Now press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to
choose one of the 3 settings by pressing the
“ENTER”
button and using the
“UP”
and
“DOWN”
buttons accordingly.
o-St
= Set the offset of the gobo wheel from 0 - +100 or -100.
The user can adjust the gobo wheel to the correct position via this option if the image
of the gobo is partially obscured.
нoto
= Review the motor reset status.
If the LED display shows
G-nG
then the gobo wheel motors position is incorrect.
If the LED display shows
G-oѢ
then the gobo wheel motor has reset successfully.
If the LED display shows
r-nG
then the rotation wheel motors position is incorrect.
If the LED display shows
r-oѢ
then the rotation wheel motor has reset successfully.
-rSt
= Resets the unit to its factory settings.
To exit out of the above, press the
“MODE”
button until you are back at the main menu.
Total reset:
In addition, if the fixture is not operating properly after powering on and menu is not operating
normally, press the “MODE” and “ENTER” buttons at the same time, then power on, until the
LED display flashes then release the buttons. Note: This will also restore the factory settings.
