Door Reversal
Use a screwdriver to remove the bottom panel cover and
disconnect the signal wire.
Use a screwdriver to remove the upper and lower hinges of the
door and remove the door.
Turn the unit sideways and reinstall the front panel.
Move the signal wire from the right side to the left side and reinstall
the bottom panel.
4. Remove screw hole cap
2. Remove upper door
hinge screws
5. Remove these screws
3. Remove lower door
hinge screws
1. Remove bottom
panel cover
6. Remove these screws
7. Move
signal
wire
Remove the handle, hole cap and door stopper.
Install them on the other side of the cabinet as shown below:
Take out the upper and lower door hinges from the accessory bag
and install the door in the corresponding position on the other side.
Ensure the hinge holes and screws are aligned and tighten the
screws to complete the door reversal process.
4