EQUATION EQ1 100L, Сборка, использование, руководство по обслуживанию

Страница: 78 / 90

78
- Heating element: the replacement of a sheathed heating element involves draining of the water
heater and replacement of the flange gasket. Reassemble the heating element, reasonably
tight nuts (cross tightening), check that there is no leakage after the first heating-up, tighten
again if necessary.
- Drain: Turn off power and cold water supply. Open hot water taps and drain valve of the safety device.
Spare parts list: flange gasket, magnesium anode (see on page 89).
Advice to the user

When the water has a TH > 20°f, it is recommended to treat it with a softener. When a
softener is used, the water hardness must remain above 15°f.

In case of prolonged absence, especially in winter, drain your appliance following the
procedure above.

This water heater is fitted with a thermostat with an operating temperature of more than
60°C at its maximum position (see diagram on page 87), capable of reducing growth of
legionella bacteria in the tank.
Caution!
Above 50°C, water could cause immediate scalds.Check the water temperature
before taking a bath or shower.
SCOPE OF THE GUARANTEE
EN
The water heater must be installed, used and maintained according to best practice and conform
to the standards in force in the country in which it is installed and to the instructions contained
in this document.
In the European Union this appliance is covered by the statutory guarantee accorded to
consumers in accordance with directive 1999/44/CE. This guarantee comes into force when
the appliance is delivered to the consumer. In addition to the legal guarantee, certain items are
covered by an extra guarantee relating only to the free exchange of the tank and of components
accepted as defective. It does not include the cost of replacement or carriage.
Refer to the table below. This commercial guarantee does not affect your statutory rights. It
applies within the country where the product was acquired, provided if it is also installed in the
same country. The dealer must be informed of any damage before the product is exchanged under
guarantee and the appliance will remain available for inspection by experts from the insurance
company and the manufacturer.
Statutory guarantee 2 years
Exclusions: Wear parts: magnesium anodes. Equipment which can not be assessed (access
difficult for repair, maintenance or assessment). Equipment exposed to abnormal environmental
conditions: frost, bad weather, water which is abnormally aggressive or outside drinking
standards, electrical supply with large spikes. Equipment installed without observing current
standards in the country of installation: the absence or incorrect fitting of safety devices, abnormal
corrosion due to incorrect water fitments (iron/copper contact), incorrect earthing, inadequate
cable thickness, non-observance of the connection drawings shown in these instructions.
Equipment not maintained in accordance with these instructions. Repairs or replacement of
parts or components in the equipment not carried out or authorised by the company responsible
for the guarantee. Changing a component does not extend the life of the guarantee.
The products illustrated in these instructions may be modified at any time to reflect changes
in manufacture and current norms.
EN