9
Important OPERATIONAL Warnings
The main power to the heater system and all other electrical components should be turned off be-
fore anyone enters the pool. Even if the thermostat or timer have paused the heater functions, live
electrical circuits are still present!
Do not operate the pool until it is full. Running the heater or other accessories without proper water
level may cause the system to operate at abnormally high temperatures, premature failure of com-
ponents, and unnecessary tripping of the high limit switch.
Do not heat water in excess of 102°F. A temperature of 100°F is considered safe for healthy adults
only. Hotter water increases a risk of hypothermia. Young children, elderly persons, persons
having medical problems and persons on medications should have special consideration.
Pregnant women need to be alerted to the danger of fetal damage and should consult their
physicians before being baptized.
Always check the water temperature using an accurate thermometer. Thermostats installed in the
system may error in regulating water temperature by as much as 4°.
Never, never tamper with the controls!. Scalding may occur if safety controls are not in proper
order.
If freezing temperatures are expected, turn off the Heater system, drain the pool, then turn off the
electrical power. Follow the Operation Instructions on page 9 for restarting the Heater.
Nothing Operates:
Main Breaker
Set to on position
Sub-panel circuit breaker
Set to on position
GFCI tripped
Set to on position
Components not plugged in
Plug in all components
Time Clock has turned system off
Adjust time clock
Overheat Protection Switch tripped
Reset High Limit Switch and monitor closely. If condition repeats,
contact Service Center.
No Pump Operation:
Timer not programmed
Program timer for on/off operation
Overheat Protection switch tripped
Reset High Limit Switch and monitor closely. If condition repeats,
contact Service Center.
Mode Switch set in Mode 2
Turn up thermostat
Air Switch activated
Press air switch again
Pump not plugged in
Plug in pump
TROUBLE SHOOTING
Warranty
Fiberglass Specialties, Inc warrants this heater to be free from defects in workmanship and materials, and we will,
within one year from date of installation, but no later than six months from time of shipment from the FSI factory, for
the original purchaser, repair, or, at our option, replace any defective part. If your system is damaged or destroyed
by improper maintenance, excessive water harshness, incorrect water chemistry, or freezing, this warranty is void.
Costs associated with removal or reinstallation of the parts, returning parts to the factory, or other incidental costs
will not be covered under this warranty. Liability shall be limited to the original purchase price of the heater system.
Fiberglass Specialties, Inc shall not be liable for any consequential damages resulting from use of this product.
If the system is draining and filling at the same time, flip the toggle switch on the drain valve to the opposite
position (see pg 10 for switch location on valve).