QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x)
80
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
Blocked IPs
When
Blocked IP List
is used, traffic from specific hosts may be
blocked, no matter what services are opened in the other filters. NO
traffic will be allowed to the specified hosts. The
Blocked IP List
service has a higher priority if the same host is also listed in the
Allowed IP List
table.
Fig.II- 110: Filtering Rules page
Allowed IPs
Allowed IP List
allows trusted hosts to reach your network and
vice versa. It is an exception to other rules and only all services may
be allowed for a single host.
Fig.II- 111: Filtering Rules page
The table displayed on the bottom of this page shows the filters selected above, specified by their
State
(enabled or disabled), the selected
Service
, the set
Action
(allowed or blocked), the IP addresses the filters apply to (if
Restricted
) and the destination of port forwarding (
Redirect to
, in case of
Incoming
Traffic/Port Forwarding
). With the exception of View All, the table offers the following functional buttons:
•
Enable
is used to enable the rule. If no records are selected the error message “No record(s) selected” will appear.
•
Disable
is used to disable the rule. If no records are selected the error message “No record(s) selected” will appear.
•
Add
opens a filter specific page where new rules may be defined by a
Service
, an
Action,
a
Restriction
to certain IP address(es) or IP groups, and if
adding a rule for
Incoming Traffic/Port Forwarding
, the destination IP address for
Forwarding
.
The page to add a rule for
Incoming Traffic/Port Forwarding
offers the following input options:
Service
includes a list of possible services to be configured. All user-defined services also will be displayed in this list.
Action
includes possible actions to setup the rule.
Forward to IP
requires the destination IP address where traffic should be transferred to if it comes from the restricted host. The IP address defined in this
field will be ignored for blocked action of the
Incoming Traffic/Port Forwarding
rule.
Please Note:
It is not allowed to forward incoming packets when the NAT service is disabled on the QX gateway.
