V120617-ESC100
7
Center Support Bar
Step 11:
Insert the
Center Support
Bar (i)
into the upper top groove on
the back of the frame with the bottom
end near the approximate center point
of the frame and rotate it in at an angle
so that both ends of the bar are in
alignment with the groove.
Attention: Do not proceed with the Edge Trim installation until making sure there are no ripples in the material.
Pre-check prior to Edge Trim Installation
Correctly distinguish the top
and bottom of the DarkStar®
UST material. Place the
assembled screen on the ground.
Look down on the screen. If the
material looks white/gray as
shown below then it is correct.
If the material looks black as
shown below, then it is upside
down.
Edge Trim Installation
Step 12
: Place the
Edge Trim
over each end of the frame and secure with
M4x6 screws (c)
.
Start with the center points first, then the rest of the corners as shown below.
