Modello - Modèle - Model
Modell - Modelo
STOK
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
20/60
N° DOC
16. TEMPERATURE SETTING AND CONTROLS
Temperature Setting and Control (Dixell Standard)
The front panel of the thermostat display:
1. Defrost indicator
2. Compressor operation indicator
3. SET key
4. Temperature modification keys
5. Defrost button
How to see the set point
• Push and immediately release the
SET
key, the set point will be showed;
• Push and immediately release the
SET
key or wait about 15s to return to normal visualisation.
How to change the set point
• Push the SET key for more than 2 seconds to change the set point value;
•
The value of the set point will be displayed and the “°C” starts blinking;
•
To change the set value push the „
˄
“ (up) or “
˅
” (down) arrows within 15s.
• To memorise the new set point value push the SET key again or wait 15s.
Automatic defrost
The appliance will automatically run defrost cycles. Note: The cycle starts from the time the appliance is initially powered up.
Manual Defrost
• Press and hold the DEFROST button for 5 seconds.
• The defrost cycle will start immediately and the Defrost LED illuminates.
Note
: Starting a manual defrost also resets the automatic defrost timer.
Temperature Setting and Control (Dixell)
The front panel of the thermostat display:
1. Thermostat Display
2. Light Key (Active on Glass Door)
3. Defrost Key
4. Stand-By Key
5. Up Key
6. Set Key
7. Down Key
LED
MODE
EXPLANATION
ON
Compressor Operation Indicator
Flashing
Compressor Start Delay Indicator
ON
Defrost enabled
Flashing
Drip time in progress
ON
Fan Operation Indicator
Flashing
Fan Delay Indicator (After Defrost)
ON
Alarm Indicator
ON
Light Indicator (active on glass door)
°C/°F
ONIn
Measurement Unit Indicator
Flashing
Programming Mode