Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET
NEXT
28 27
TM-T88
III
series
Specification
(STANDARD)
B
2.2.3 Drawer Kick-out Connector (Modular Connector)
The pulse specified by
ESC p
or
DLE DC4
is output to this connector. The host can confirm the status
of the input signal by using the
DLE EOT
,
GS a
, or
GS r
commands.
1) Pin assignments:
Refer to Table 2.2.2
Table 2.2.2 Drawer Kick-out Connector Pin Assignments
Pin Number
Signal Name
Direction
1 Frame
GND
—
2
Drawer kick-out drive signal 1
Output
3
Drawer open/close signal
Input
4 +24
V
—
5
Drawer kick-out drive signal 2
Output
6 Signal
GND
—
+24 V is output through pin 4 when the power is turned on. However, pin 4 must be used only
for the drawer.
1
6
Figure 2.2.2 Drawer Kick-out Connector
2) Connector model:
Printer side: MOLEX 52065-6615 or equivalent
User side:
6-position 6-contact (RJ12 telephone jack)
3) Drawer kick-out drive signal
Output signal:
Output voltage:
Approximately 24 V
Output current:
1 A or less
CAUTION
: To avoid an overcurrent, the resistance of the drawer kick-out solenoid must be 24
Ω
or more.
Output waveform:
Outputs the waveforms in Figure 2.2.3 to the points A and B in
Figure
2.2.4.
t1
(ON time) and
t2
(OFF time) are specified by
ESC p
or
DLE DC4
.
t 1x 2 msec
t 1x 2 msec
Figure 2.2.3 Drawer Kick-out Drive Signal Output Waveform
t2
x 2 ms
t1
x 2 ms