Epson TM-C100, Техническое справочное руководство

Страница: 33 / 64

Rev. C Using the Printer 3-3
TM-C100 Technical Reference Guide
CAUTION:
Attempting to remove the roll paper edge guide without squeezing the locking clip
may damage the components. Always squeeze the clip when removing the guide.
4. Remove the used roll paper core if there is one. If there is roll paper inside the printer,
remove it also.
5. Pull up the edge of the new roll paper approximately 10 cm {4 in}. Check the label
instructions for the proper direction for the paper to come off of the roll.
6. Slide the roll paper onto the shaft of the roll paper holder while inserting the end of the roll
paper into the slot in the middle of the printer, as shown below.
7. Insert the roll paper as far as it will go.
8. Insert the roll paper edge guide onto the roll paper holder while squeezing the locking clip
of the edge guide.
Note:
Adjust the edge guide so that there is no space at either edge of the roll paper.
9. Check that the installed roll paper is straight.
10. Press the release lever again to close the paper entrance.
11. The paper is cut and fed to the print starting position.
Note:
If the printer is not turned on when the release lever is pressed down, the paper will not be positioned.
In this case, operate the release lever with the power turned on, and clamp it again.