Common CorelDRAW tasks continued
Sublimation printable's hints and tips
Sizing images
There are many ways to resize an object in CorelDRAW. You can click and drag the selection handles around the object
by using the pick tool.
Property bar
You change the dimensions of an object proportionally by preserving its aspect ratio. You can size an object’s dimensions
by specifying values or changing the object directly. Scaling changes an object’s dimensions by a specified percentage.
You can change an object’s anchor point from its centre to any of its eight selection handles.
You can also click on the object you wish to re-size and type in the object size box. If you lock the non-proportional scaling/
sizing ratio the width and height of the object will scale/size in proportion. If you un-lock it, you can make the object any size
you wish.
Duplicating objects
There are a couple of ways you can duplicate objects on CorelDRAW. The easiest but
not that accurate in terms of plotting your design out is to select the object with the
pick tool, then press CTRL+D. You can then place the image manually on the layout
screen.
The accurate way to duplicate objects is to use the Transformation docker window.
Click on Arrange > Transformations > Position. The Transformation docker window
will pop up on the right hand side in CorelDRAW. When you select an object the Position,
relative position and the apply buttons will illuminate. The example on the right shows an
object which is selected and ready to be duplicated. To increase or decrease the horizontal
positioning enter the size or click the up/down arrows. This function specifies the
duplication distance from the original object.
The relative position option is there to select where you want the duplicated object
to appear. On the example I have selected the duplicate to appear on the left of the
original object. Now click 'Apply To Duplicate' to duplicate the object(s).
From the transformation docker window you can also select Rotate, Scale and mirror,
Size and skew.
Some sublimation printable's (substrates) have a protective coating on which must be removed before pressing.
The most common of these is the desk clocks, all pre-cut metal, hardboard placemat's and coasters. Also check
other plastic products for coatings.
Ensure the substrate is facing up when placed on the heat press and the transfer is face down onto it. If this is not
done you will get a faded or no image transferred to the substrate.
Sublimation mugs differ in time and temperature depending which mug you are using. All times and temperatures
below are based on the Xpres Mug Press 2000.
XP5013 Coated ceramic mugs
- Time 3min 30sec at 200°c (increase time to 4min 30sec for top to bottom mug printing).
XP5011 Colour change mugs
- Time 3min 30sec at 190°c (increase time to 4min 30sec for top to bottom mug printing).
XP5015 Coated metallic mugs
- Time 3min 30sec at 200°c (increase time to 4min 30sec for top to bottom mug printing).
XP5014 Coated porcelain mugs
- Time 3min 30 sec at 200°c (top to bottom is not recommended for this type of mug).
XP5013
and
XP5014
are dishwasher safe.
Tip
: Refer to the Xpres sublimation printables wall chart or product information sheets for times and temperatures for
other products.
Object
position
on page
Object
size
Scale
factor
Non-proportional
scaling/sizing
ratio
Selection
handles
10
Содержание Subli-Print 4450
Страница 1: ...Epson 4450 Subli Print Instruction Manual ...
