Epson Stylus Pro 7890 Series, Руководство по обслуживанию, Страница: 114 / 519

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
TROUBLE SHOOTING Remedies for Error Messages 114
Confidential
8 PAPER SENSOR ERROR
PRESS THE
BUTTON
LOAD DIFFERENT PAPER
The barcode has not been read correctly. Press the button to clear the error, or press the button to
release the paper presser to set a different paper.
The barcode has not been read because there is something
wrong with the Ink Mark Sensor. Check if there is any foreign material such as paper dust stuck on the
sensor.
Check the connection between the Ink Mark Sensor and the Main Board
Assy.
Replace the Ink Mark Sensor.
(See P.298)
9 PAPER LOW The roll paper is close to running out. Replace the roll paper with a new one.
10 BORDERLESS ERROR
LOAD A SUPPORTED PAPER SIZE
OR LOAD PAPER CORRECTLY The paper installed is not supported for borderless printing. Press the button to cancel jobs, and then eject the paper. Then
load a different size of paper.
The size of the cut sheet paper is not recognized correctly. If the paper is wavy or slack, the printer cannot recognize the paper size
correctly. In this case, flatten the paper before loading it in the printer.
The paper is not set correctly. Set the paper correctly in the printer.
The paper width cannot be detected correctly because there
is something wrong with the PW Sensor. Check if there is any foreign material such as paper dust stuck on the
sensor.
Check the connection between the PW Sensor and the Main Board
Assy.
Replace the PW Sensor.
(See P.251)
11 PAPER EJECT ERROR
REMOVE PAPER FROM PRINTER The roll paper is not ejected correctly. Press the button to release the paper presser, and then remove the
paper.
12 PAPER SIZE ERROR
LOAD CORRECT SIZE PAPER The loaded paper size does not match the data size. Match the loaded paper size to the data size.
13 PAPER JAM
REMOVE PAPER The paper is jammed. Remove the jammed paper.
The PE Sensor is malfunctioning due to some foreign
material. Remove the foreign material.
14 FRONT COVER OPEN
CLOSE FRONT COVER The Front Cover is open. Close the Front Cover.
The Front Cover (Middle) or the Front Cover Sensor (L/R)
is/are broken. Check the installation status of the Front Cover (Middle).
Confirm that the actuator of the Front Cover (Middle) presses the Front
Cover Sensor (L/R).
Check the connection between the Front Cover Sensor (L/R) and the
Main Board Assy.
Replace the Front Cover Sensor (L/R) with new ones.
(See P.221,
P.223)
No. Message on LCD Description Remedy/Points to be checked