Epson Stylus Pro 7400, Руководство по обслуживанию

Страница: 270 / 428

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 270
10. Remove the three screws that secure the PRINT HEAD and remove it. See Figure
4-109.
„ Three C.B.P. M2.6 x 6 screws
11. Peel off the two Head FFCs secured to the PRINT HEAD with two-sided tape, and
then disconnect the FFCs from the PRINT HEAD. See Figure 4-110.
Figure 4-109. Screws Securing the PRINT HEAD
Figure 4-110. Disconnecting the Head FFC
When removing the PRINT HEAD, the ABSORBER, CR may
come off the HOLDER, HEAD. If this occurs, attach the
ABSORBER, CR as shown in the figure below.
Figure 4-108. Reinstalling the ABSORBER, CRs
A D J U S T M E N T
R E Q U I R E D
Whenever the PRINT HEAD is reinstalled or replaced, the
corresponding adjustment must be carried out.
See Chapter 5 on
page 292. When replacing the PRINT HEAD with a new one, note
down the 40-digit Head Rank ID indicated on the ID label affixed to
the new PRINT HEAD.
See Figure 4-109.
ABSORBER, CRs
PRINT HEAD Head Rank ID Label
C.B.P. M2.6x6
Head FFC
Two-sided
Tape