Epson Stylus COLOR 3000, Руководство пользователя, Страница: 192 / 286

The banner mode setting is
on. Make sure the banner mode setting is
off. If this setting is on, the printer
feeds paper a specified length. Change
this setting using the default-setting
mode. See “Using the Default-Setting
Mode” on page 6-4.
Paper feeding is crooked.
Cause What to do
The edge guide of the sheet
feeder may not match the
paper’s width. Adjust the edge guides.
There may be too much
paper in the sheet feeder. Remove some paper.
You are printing on oversized
paper, and the paper may be
obstructed by the output tray. Raise the output tray by extending the
legs under both sides of the tray to
keep enough clearance between the
output tray and paper support. See
“Loading oversized paper into the
sheet feeder”on page 5-3.
Single sheets are not loaded
deeply enough. Load single sheets in the manual feed
slot until thet they meet resistance.
The paper may be old or
creased. Use only new, smooth sheets of paper.
The paper does not meet the
requirements of this printer. Make sure that your paper is the
proper size and quality. See page D-4.
L
Loire-P Ref. Guide
Rev.c
A5 size Chapter 8
02-24-97 DR, pass 0
8-20 Troubleshooting