❑
The paper was exposed to excess humidity, over 60%. See
Appendix B for specifications on required environmental
conditions.
❑
The left edge guide is too tight or too loose; adjust it for the
size of the paper.
❑
The thickness adjustment lever is set incorrectly for the
media; see “Setting the Thickness Adjustment Lever” in
Chapter 1.
❑
Continuous paper may be in the paper path when you
print from the sheet feeder. Remove the continuous paper.
❑
The paper-release lever is set to the wrong position; see
“Switching Between Continuous Paper and Single Sheets”
in Chapter 1.
❑
Too many sheets are loaded in the sheet feeder. You can
load up to 100 sheets of plain paper, 70 sheets of special
coated paper, 10 envelopes, 50 sheets of transparency film,
or 30 sheets of high-quality glossy paper.
❑
When printing on oversized paper, make sure the paper is
not obstructed by the output tray.
Continuous Paper Problems
See this section for solutions to problems with continuous
paper.
Regular gaps occur in continuous paper printout.
Skip-over-perforation may be on. Set skip-over-perforation to
off. See “Using the Default Setting Mode” in Chapter 2.
Troubleshooting
4-13
