Epson S5U1C62N51E1, Руководство пользователя

Страница: 11 / 16

S5U1C62N51E1 MANUAL (Rev.1.0)
EPSON
7
4. CABLE CONNECTION
This section describes how to connect the power cable to the S5U1C62N51E1, and the S5U1C62N51E1 to the ICE
and the target system.
Note: Turn the power of all equipment off before connecting or disconnecting cables.
4.1 Connection to ICE
The S5U1C62N51E1 is connected to the ICE by connecting the two interface cables (F1 and F5). Use
S5U1C62N51E1 connectors F1 and F5 with the projections facing outwards. Use ICE connectors F1 and F5 with
the projections facing inwards (cable side).
Figures 4.1.1 and 4.1.2 show the external view and connection diagram of the ICE interface cable.
2 1
50 49
2 1
50 49
:
:
:
:
: :
:
:
:
: :
:
:
:
: :
:
:
:
:
ICE side S5U1C62N51E1 side
ICE
F1
F5
S5U1C62N51E1
Red mark
Fig. 4.1.1 External view of the ICE interface cable Fig. 4.1.2 Connection diagram
Note: The S5U1C62N51E1 has an external power input connector for +5 V (V
DD
) and GND (V
SS
). Leave these
connectors unconnected when the S5U1C62N51E1 is connected to the ICE.
-
+
Connect to the
power connector
of the S5U1C62N51E1 Connect to the
external power
supply
Black
Red
Fig. 4.2.1 Connection of power cable pins
4.3 Connection to Target System
The I/O #0 and LCD #0 connectors are used to
connect the S5U1C62N51E1 to the target system.
S5U1C62N51E1
I/O #0
Front
LCD cable
I/O cable
I/O
LCD
Target
system
connector
connector
LCD #0
4.2 Power Cable Connection
When using the S5U1C62N51E1 on its own, it must
be supplied with power (5 V DC, 3 A or more) from
an external source through the power cable.
When the S5U1C62N51E1 is connected to the ICE,
power is supplied by the ICE; therefore, the power
cable is not necessary. Disconnect the power cable if
it is already connected.
Figure 4.2.1 shows the connection of the power cable
pins.
4. CABLE CONNECTION
Fig. 4.3.1 Connection of target system
The signals output from the LCD #0 connector are
the same as those of the actual IC at the function
level. Therefore, the S5U1C62N51E1 may be
connected to the LCD of the target system without
any changes.