S1D13517 Display Controller
S5U13517P00C100 Evaluation Board User Manual (Rev. 1.0)
EPSON
7
Chapter 3 Installation and Configuration
The S5U13517P00C100 evaluation board incorporates a DIP switch, jumpers, and 0 ohm resistors which allow it to
be used with a variety of different configurations.
3.1 Configuration DIP Switch
The S1D13517 has 2 configuration inputs (CNF[1:0]). A DIP switch (SW1) is used to configure CNF[1:0] as
described below.
The following figure shows the location of DIP switch SW1 on the S5U13517P00C100 board.
Figure 3-1: Configuration DIP Switch (SW1) Location
Table 3-1: Summary of Power-On/Reset Options
SDU13517P00C100
SW1-[2:1] Config
S1D13517
CNF[1:0] Config
Power-On/Reset State
1 (ON)
0 (OFF)
SW1-[1]
CNF0
Host data bus is 8-bit
Host data bus is 16-bit
SW1-[2]
CNF1
Host interface is ALE bus
Host interface is i80 bus
= Required settings when using S5U13U00P00C100 USB Adapter board
DIP Switch
SW1
