3. Setup of Software Development Environment
4
Seiko Epson Corporation
S1C31 Family Software Development
Setup Guide (Rev.4.0)
3. Setup of Software Development Environment
This chapter describes the procedure for setting up the software development environment obtained in Chapter 2.
3.1 Installation of IDE
This section describes the procedure to install IAR EWARM and MDK-ARM.
3.1.1
When Using the IAR EWARM
Install the IAR EWARM by following the procedure shown below.
(1) Download the installer of IAR Embedded Workbench for ARM from the web site of IAR Systems.
(2) Finish all the application on the Windows.
(3) Double click the installer(exe file) to launch it. Then the installation screen shown below will be displayed.
(Figure 3.1.1.1)
(4) Click [Install IAR Embedded Workbench
®
] to start the installation wizard. (Figure 3.1.1.1)
Figure 3.1.1.1 Installation Screen of IAR Embedded Workbench for ARM
(5) Follow the prompts in the installation wizard to proceed with the installation. The recommended settings are
as follows.
•
Installation directory: Default location
•
Installation option:
Full installation
If you launch the IAR Embedded Workbench for the first time after installation, license registration will be
requested. The procedure of license registration varies depending on the type of license you purchased. For more
information on the procedure of license registration, refer to “Quick Reference”(listed in Table 2.2.1).
