Epson RX595 - Stylus Photo Color Inkjet, Руководство по обслуживанию, Страница: 92 / 131

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 92
4.5.8 Upper Paper Guides
1. Remove the Printer Mechanism (p.76)
2. Remove the I/S Assy (p.84)
3. Remove the ASF Assy (p.85)
4. Remove torsion springs (x3) at the rear of the printer. (Fig. 4-80)
5. Release the hooks (x3), release the Upper Paper Guides from the shaft holders of
the printer frame, lower the actuator of the PE Sensor, and remove the Upper
Paper Guides.
(Fig. 4-81)
Figure 4-79. Upper Paper Guides Layout (rear of the printer)
Figure 4-80. Removing the Springs
Figure 4-81. Removing the Upper Paper Guides
C A U T I O N
„ When removing the Upper Paper Guides, bring down the
actuator of the PE Sensor toward the front to avoid damaging
it.
„ Do not touch any of the rollers; otherwise, the print quality
may drop.
C H E C K
P O I N T
The Upper Paper Guides are connected as a single unit with thin
fragile bridges as shown with arrows below. However, these parts
are not to be placed on the shaft holders of the printer frame.
Therefore, it is not necessary to replace the Upper Paper Guides
even if the bridges are broken.
Install the springs properly, while paying attention to the tip
position of each spring.
(Fig. 4-80)
Do not touch
Thin Thin
Spring (x3)
Upper Paper Guides
Hooks
PE Sensor
~Rear~
~Front~ ~Rear~
Tip of spring
Spring (x3)
Release the hooks and lift
the Upper Paper Guides
Bring down the actuator