Epson RX595 - Stylus Photo Color Inkjet, Руководство по обслуживанию, Страница: 75 / 131

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Removal of Exterior Parts 75
4.2.7 Linear Scale
1. Remove the Panel Assy (p.63)
2. Remove the Scanner Unit (p.65)
3. Remove the Main Board Assy / Case Open Sensor (p.66)
4. Remove the Waste Ink Tray Assy (p.69)
5. Remove the Middle Housing Assy (p.70)
6. Remove the spring from the left frame of the printer. (Fig. 4-36)
7. Release the Linear Scale from the hook at the right frame of the printer.
8. Pull out the Linear Scale from the CR Encoder of the Carriage Assy.
9. Turn the Linear Scale upward by 90 degrees and release it from the left hook.
Figure 4-36. Removing the Linear Scale
C A U T I O N
„ When you hold the Linear Scale, hold its ends or two points of
the top and bottom surfaces with your hands; do not touch the
reading surface.
„ Take care that the reading surface is not soiled or scratched.
Especially when passing the Linear Scale through the CR
Encoder during reassembly work, take great care that grease of
the CR Guide Shafts does not adhere to the reading surface.
C H E C K
P O I N T
If you need to move the Carriage Unit, unlock the Carriage in
advance.
( See 4.1.5 How to Unlock the Carriage (p.61) )
CR_Scale02.eps
About 25mm About 45mm
Hold here
Hold here Hold here
Hold here
Install the Linear Scale with the cut portion upward.
Carriage Assy
6. Remove the spring
7. Release it from the hook
8. Pull it through the CR Encoder
9. Turn it by 90 degrees and release it
Cut portion