GPS Running Watch
Quick Start Guide
Buttons
1
Charging the Watch
2
Setting Up the Watch and App
57
Make sure to read the
Notices
sheet and online
User’s Guide
before using the product to ensure safe use.
Use the included USB charging clip to charge
the watch.
1
Connect the USB charging clip to the watch.
2
Connect the USB cable to your PC or the
optional AC adapter.
Make sure the watch is fully charged before you
remove the clip.
The Settings screen appears on the watch after
you remove the USB charging clip.
1
On the watch, select your language and
press
Enter
.
2
Select
Set by Phone
and press
Enter
.
Note:
You can also use a PC to configure the
watch or you can configure the watch on
its own. See the online
User’s Guide
for more
information.
3
Download and install the Epson View app
from your smartphone’s app store.
4
Launch the Epson View app and create
an account or log in. After you finish this
process, the initial Settings screen appears
on your smartphone.
Note:
Once you have completed the initial
setup, you can use the Epson View app to
customize the workout screens, change
settings, and link to third-party fitness apps.
3
Using Your Watch
Selecting a Workout Mode
1
Press
down on the Time screen to display
the workout mode screen.
Note:
You can press
Start/Stop
on the
Time screen to quickly start a run.
2
Press
up or
down to select the
desired activity.
The following workout modes are available:
Run
Walk
Treadmill
3
Press
Start/Stop
while outdoors with no
obstacles overhead to start GPS calibration.
You can start your workout when the
Measurement screen appears.
For increased GPS accuracy, wait at least 15
minutes before starting your workout. You
only need to perform this extended GPS
calibration the first time you use the watch
or if you do not use it for a few months.
Note:
If you see the message below, do one
of the following:
•
Move to an area with no obstructions
overhead and then press
back to
restart GPS calibration.
•
Press
Enter
to start the workout.
Distance traveled will be estimated until
the GPS signal is fully acquired.
Starting a Workout
Press
Start/Stop
on the Measurement
screen to start a workout.
Note:
You can press
Enter
during a
workout to start and record a new lap.
Press
up or
down during a workout to
change the measurements that appear. See
the online
User’s Guide
for more information.
5
Note the code that appears on the watch.
6
Select
ProSense 57
from the list on your
smartphone, then follow the instructions to
pair your watch and your phone.
The Time screen appears on the watch when
the process is complete.
Note:
You can pair the watch with your
smartphone at any time by selecting
My
Watch
in the Epson View app.
Back
Start/Stop
Up
Enter
Down
Wearing Your Watch
Wear the product snugly
around your wrist as shown.
Tighten the watch if your
pulse is not measured
correctly while exercising.
ProSense57_QSG_E_CPD54150_2pages.indd 1
7/14/17 2:11 PM
