Epson NX215 - Stylus Color Inkjet, Руководство по обслуживанию

Страница: 108 / 184

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510 Revision A
DISASSEMBLY/ASSEMBLY Removing the Circuit Boards 108
Confidential
4.4.2 Panel Unit/LCD Unit
† Parts/Components need to be removed in advance: None
† Removal procedure
1. Open the Scanner Unit.
2. Raise the LCD Unit.
3. Lifting the front of the Panel Unit, and release the tabs of it.
4. Slide the Panel Unit in the direction of the arrow, and release the hooks of it
from the Upper Housing.
Figure 4-25. Removing the Panel Unit and LCD Unit (1)
A D J U S T M E N T
R E Q U I R E D
„ NX510 series only:
When replacing the Main Board, the MAC address need to be
set if the EEPROM data could not be read from the old Main
Board. In this case, attach the new “Label, MAC address
(Parts number:
TBD )” to the position shown in Figure 4-24
and execute “ 5.2.8 MAC Address Setting (NX510 series only) ”
(p173) .
Figure 4-24. Position for the MAC Address Label
„
Whenever the Main Board is removed/replaced, the required
adjustments must be carried out.
•
Chapter 5 “ ADJUSTMENT” (p.161)
Label, MAC address
Main Board Unit
C H E C K
P O I N T
See the following because the disassembling/reassembling
procedures of the Panel Unit/LCD Unit for SX410/SX210 series
differ from those of NX510 series.
„ SX410 series:
“ 4.7.2 Panel Unit/LCD Unit (SX410 series) ” (p148)
„ SX210 series:
“ 4.8.2 Panel Unit/LCD Unit (SX210 series) ” (p155)
C A U T I O N
Do not lift the Panel Unit too far, since the Panel FFC is connected
to it.
Panel Unit
LCD Unit
Hook
Tab
Backside
Upper
Housing