Epson EB-G6800, Руководство пользователя

Страница: 89 / 173

Submenu Function
Sync.
(Only available when an analog RGB computer signal is being
input.)
You can adjust computer images when flickering, fuzziness, or
interference appear in the images.
Position You can adjust the display position up, down, left, and right when
a part of the image is missing so that the whole image is projected.
3D Setup When projecting passive 3D images using two projectors, set 3D
Images
to
On
.
Progressive
Interlace
g
(i) signal is converted to Progressive
g
(p). (IP
conversion)
Off
: Ideal for images with a large amount of movement.
Video
: Ideal for general video images.
Film/Auto
: This is ideal for movie films, computer graphics, and
animation.
Frame Interpola-
tion (EB-
G6900WU only)
You can play fast moving images smoothly by producing
intermediate frames between the original frames.
Noise Reduction
(This cannot be set when Image Processing is set to Fast .)
Smoothes out the roughness in progressive images. There are
two modes. Select your favorite setting. It is recommended that
this is set to
Off when viewing image sources in which noise is
very low, such as for DVDs.
Mosquito NR
(This cannot be set when Image Processing is set to Fast .)
When a progressive signal is being input, you can reduce the
wavy noise that occurs in lines between areas with dramatic
changes in colors.
Video Range
Select the video range for the input signal from the HDMI port,
the DisplayPort, HDBaseT port, or the SDI port (EB-G6900WU
only). Set to
Expanded if you are concerned about misadjusted
black levels or blown out highlights in the image.
Submenu Function
Input Signal
You can select an input signal from the Computer port or BNC
port.
If set to
Auto , the input signal is set automatically according to
the connected equipment.
If colors do not appear correctly when set to
Auto , select the
appropriate signal according to the connected equipment.
Video Signal You can select an input signal from the Video port or S-Video
port. If set to
Auto , video signals are recognized automatically. If
interference appears in the image or a problem occurs such as no
image is being projected when set to
Auto , select the appropriate
signal according to the connected equipment.
Aspect
You can set the aspect ratio
g
for projected images.
s
"Changing the Aspect Ratio of the Projected Image " p.50
Scale
When using multiple projectors to project one image, adjust the
range of the image displayed by each projector.
s
"Scaling an Image (Scale)" p.64
Overscan
(This setting can only be adjusted when a component video
signal is being input.)
Changes the output image ratio (the range of the projected
image). You can set the cropping range to
4% or 8% . When set to
Auto
, this is automatically adjusted according to the input signal.
Image Process-
ing
Changes settings for image processing.
Fast : Images are displayed quicker.
Fine : Images are displayed in higher quality.
DisplayPort EQ
Setting
Adjusts the DisplayPort input signal level depending on the
devices connected to the DisplayPort. If there is a lot of
interference in the image, or if a problem such as no image being
projected occurs, select
1 or 2 , and then confirm the selection.
List of Functions
89