Epson C82324*, Руководство пользователя

Страница: 24 / 57

4.
5.
6.
7.
8.
9.
10.
Select “Install New Ethernet Interface Card.”
Enter the eight-digit Ethernet Card serial number. The serial
number is located on the component-side of the interface
board. You should already have written it down on page
1-2 and in the space provided at the front of this manual
when you installed the Ethernet Card board in the printer.
Select “Remote Printer Mode” for the operating mode. (For
instructions on installing as a print server, see “Installing as a
Print Server” earlier in this chapter.)
In the Novell print server list, select the print server configured
earlier.
Select LPT1.
Enter the number of the print server port (0-15) to which you are
assigning the Ethernet Cards port. (You selected the print
server port in step 9 in the previous section.)
When you finish configuring the Ethernet Cards port, press
ESC.
Select “Yes” to install and reset the remote printer.
Select “No” for further configuration. To exit without
installing, press
ALT X.
Caution:
Once you select “Yes," you must wait for the “Installation has
been completed”
message to appear before
turning off the printer.
Turning off the printer before completion could erase the
interface’s memory; this could make the interface board unusable.
After a successful setup, the Ethernet Card’s red light goes off, the
green light lights, and the printer prints a configuration report
(unless configured to suppress configuration reports).
Installing the Ethernet Card
1-9