36
Notices
Notices
Important Safety Instructions
Before using your Epson product, read and follow these safety instructions:
■
Be sure to follow all warnings and instructions marked on the product.
■
Use only the type of power source indicated on the product’s label.
■
Use only the power cord that comes with the product. Use of another cord may cause fires or
shock. Do not use the cord with any other equipment.
■
Place the product near a wall outlet where the plug can be easily unplugged.
■
Avoid plugging the product into an outlet on the same circuit as a photocopier or air
conditioning system that regularly switches on and off, or on an outlet controlled by a wall
switch or timer.
■
Do not let the power cord become damaged or frayed. Place it to avoid abrasions, cuts, fraying,
crimping, and kinking. Do not place objects on top of it and do not allow it to be stepped on or
run over. Be careful to keep the cord straight at each end.
■
If you use an extension cord with the product, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s
ampere rating.
■
Always turn off the product using the
P
power button, and wait until the
P
power light stops
flashing before unplugging the product or cutting off power to the electrical outlet.
■
If you will not be using the product for a long period, unplug the power cord from the electrical
outlet.
■
Place the product on a flat, stable surface that extends beyond its base in all directions. It will
not operate properly if it is tilted or at an angle.
■
Make sure the product is at least 4 inches (10 cm) away from the wall.
■
Leave enough space in front of the product for the paper to be fully ejected.
■
Allow space behind the product for the cables, and space above the product so that you can
fully raise the document cover.
■
Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or
dust. Do not place the product near excessive heat sources or in direct sunlight. Do not place or
store the product outdoors.
■
Leave enough room around the product for sufficient ventilation. Do not block or cover
openings in the product case or insert objects through the slots.
■
Keep the product away from potential sources of electromagnetic interference, such as
loudspeakers or the base units of cordless telephones.
