EPSON PhotoPlus
NOTE
If you have a Iow-profile computer and the PhotoPlus
parallel connector does not fit in the port, use an extender
connector.
3.
Plug the power adapter into the power socket on the
PhotoPlus parallel connector.
r
power socket
4.
To connect the printer and the PhotoPlus scanner to
the same port, plug the printer cable into the
PhotoPlus parallel connector as shown and tighten
the screws.
5.
Plug the PhotoPlus power adapter into a grounded
electrical outlet. To protect the scanner from
interference, it is best to use a surge protector.
NOTES
lf you connect your printer and PhotoPlus scanner to the
same port, the printer must be turned on when you use
the scanner.
The scanning head on your PhotoPlus may loosen
during shipping. Before you scan, push down to
make sure if is firmly seated on the base.
Hand Scanning
1.
Set up the PhotoPlus software for hand scanning.
2.
Remove the PhotoPlus scanning head from the base
by pushing it up, as shown.
3.
Place the image you want to scan on a flat surface.
4.
Place the scanning head on the image, aligning the
front-left scanning guide with the left edge of the
image, as shown below:
scannin
guide
Click Start or press the button on the scanner. The
scanning light turns on.
Move the scanner very slowly down the image,
making sure you keep it straight. If the scanner
beeps, you need to slow down.
Scanning stops when you reach the set height or
length. (If you want to stop before this point, press
Esc.) When scanning is complete, click Transfer. The
PhotoPlus screen displays the image.
To replace the scanning head on the scanner, align
the tabs in the base with the holes in the scanning
head as shown below, and then lock it into position.
Scanner
6/96
EPSON PhotoPlus-3
