Setting the Standby Timer
Standby Timer allows you to set a timeout period for the LCD
display panel if the Display option is set to PANEL. When you
select Standby Timer you see this menu:
Select Timer
to
set a timeout period, or select Normal to disable
standby mode. When you select Timer, you see these prompts:
Standby Time (minutes) :
Time-out on (K)eyboard activity or (M) emery
access (K/M) :
Enter the number of minutes to wait before entering standby mode
and press
Enter.
Then enter
K
or M to indicate the type of activity.
If you enter K, the LCD panel will enter standby mode if there is
no keyboard activity for the specified number of minutes. If you
enter M, the LCD panel will enter standby mode if video memory
is not accessed for the specified number of minutes. Press
PgDn
to
initiate the timer.
The standby mode initiated by the VGACONF utility does not
work in Windows. You may prefer to use the power management
features available through Setup.
Select Quit to exit the VGACONF program and return to the
operating system prompt.
6-6
Using the VGA Utilities
Содержание ActionNote 4SLC2-50
