EPSON FX-890/2190
Revision B
Disassembly and Assembly
Main Components Disassembly
76
4.2.4 C524PSB/PSE/PSH Board
1.
Perform Pre-Disassembly. (p.70)
2.
Remove the Upper Housing. (p.72)
3. Remove the shield cover.
4. Disconnect the harness from the connector CN14 on the C524MAIN board.
5. Disconnect the power cable from the connector CN1 on the C524PSB/PSE/PSH
Board.
6. Remove the 2 CBP (M3x12) screws securing the C524PSB/PSE/PSH Board to the
Lower Case, and remove the C524PSB/PSE/PSH Board.
Figure 4-11. C524PSB/PSE/PSH Board Removal
W A R N I N G
Before disassembling, assembling or adjusting the printer,
disconnect the power supply cable from the AC power socket.
Failure to do so might cause personal injury.
Do not touch the heat sink attached to the switching FET (Q1)
on the power supply board right after power off as it may be
very hot.
CN14
CBP Screws (3x12) x2
Tightening Torque: 0.88±0.1 N.m
C524PSB/PSE/PSH Board
CN1
Содержание 890N - FX B/W Dot-matrix Printer
