CHAPTER 2: INSTALLING S5U1C63002P
2
EPSON
S5U1C63002P MANUAL
(PERIPHERAL CIRCUIT BOARD FOR S1C63158/63358)
•
Installing the Peripheral Circuit Board
Set the jig included with the ICE into position as
shown below. Using this jig as a lever, push it
toward the inside of the board evenly on the left
and right sides. After confirming that the
Peripheral Circuit Board has been firmly fitted
into the internal slot of the ICE, remove the jig.
•
Dismounting the Peripheral Circuit Board
Set the jig included with the ICE into position as
shown below. Using this jig as a lever, push it
toward the outside of the board evenly on the
left and right sides. After confirming that the
Peripheral Circuit Board has been dismounted
from the backboard connector, pull the Periph-
eral Circuit Board out of the ICE.
Peripheral Circuit Board
Peripheral Circuit Board
Fig. 2.1.2 Installing the Peripheral Circuit Board
Fig. 2.1.3 Dismounting the Peripheral Circuit Board
CHAPTER
2 I
NSTALLING
S5U1C63002P
2.1 Installing the S5U1C63002P in the ICE (S5U1C63000H1)
(1) Unfasten the screws located on the left and right sides of the front panel of the ICE by turning them
counterclockwise, then remove the front panel.
(2) Insert the S5U1C63002P board into the ICE along the 2nd guide rails (lower slot) until the tip of the board
touches the back of the ICE. If some other board is mounted on the guide rails, remove that board by using
the jig supplied with the ICE before you insert the S5U1C63002P board (see Figure 2.1.3).
(3) Once the S5U1C63002P board has been inserted almost fully into the ICE, secure it in position by
using the jig supplied with the ICE (see Figure 2.1.2).
(4) In a similar fashion to Step (2), insert the S5U1C63003P board into the ICE along the uppermost guide
rails (upper slot).
(5) In a similar fashion to Step (3), secure it in position.
(6) When the above is done, replace the front panel.
(2)
(3)
(4)
S5U1C63003P Board
S5U1C63002P Board
(5)
(1), (6)
Fig. 2.1.1 Installing the S5U1C63002P board in the ICE
