EPS 301, Руководство по эксплуатации и установке

Страница: 10 / 24

8
MOTOR CONTROL BOARD
DESCRIPTION OF FUNCTION SWITCHES
SETTING SWITCH#
OPEN (OFF) 1 P1: Requires that open signal be
set, then reset prior to
opening gate.
CLOSED(ON) 1 P1: When other conditions allow,
initiates immediate opening
after setting of open input.
OPEN (OFF) 2 P2: Requires that close signal be
set, then reset prior to
closing gate.
CLOSED (ON) 2 P2: When other conditions allow,
initiates immediate closure
after setting of close input.
CLOSED (ON) 3 LATCH: Causes immediate closing of
gate following setting and
resetting of safety while gate
is on open limit, if open
signal in not present.
CLOSED (ON) 4 INTERRUPT: Stops all gate movement
when safety is set, hold until
safety is reset.
OPEN (OFF) 4 INTERRUPT: Stops gate from closing
when safety is set. Prevents
closing until safety is reset.
CLOSED (ON) 5 SEQUENCE: When gate is on open limit,
will initiate closure after
receiving open signal.
CLOSED (ON) 6 REVERSE: Causes gate to open
following a stop or safety
input, unless gate is on close
limit.
CLOSED (ON) 7 WAIT: Causes a 2 second delay in
any change in gate motion
direction.
OPEN (OFF) 8 CLOSE TIMER: Starts when gate reaches
open limit, if open signal is
not present and safeties are
reset. Open input and
safeties when on will hold
timer off until cleared.
OPEN (OFF) 9 BRAKE: Provides power to opposite
motor winding momentarily
upon reaching either limit
switch.
NOTE: On all configurations, switch 9 must be off for the brake to be active, and switch 8 must be off for closing
timer to be active.